Answered: OBD2 scanner code P0603 on 2006 Nissan Frontier Nisma Offroad
HI there, The code indicates there is a power issue to the ecm. This is fuse #53 in the IPDM which is the large fuse and relay box under the hood. If the ecm is not getting power through the IPDM it...
View Article2007 maxima electric driver's seat
Please help! Having problems with the driver's seat. Everything works except that the seat doesn't go forward nor backward. Tried pressing the seat memory and the seat doesn't move at all. Disconnected...
View ArticleClik here to view.
Nissan Intelligent Keys Tips and Chart
The Intelligent Keys used on late model Nissan and Infiniti vehicles may NOT be interchangeable between models and years. Although the Intelligent Keys may look the same on the outside (physical...
View ArticleBlower problems
Looking for some help on my 2005 Xtrail....the other day, I put the fan on Max for a few minutes (very hot day) but when I tried to turn it down or off, it would not. Fan ran full blast until ignition...
View ArticleWindow master switch replaced...still not working.
My driver side window wouldn't work, all other buttons worked just not the driver side window. I replaced the master switch, but it still isn't working. Now sure what to do at this point?
View ArticleAnswered: Removal and replacement of ASCD switch on 2005 Nissan Altima
Hi there, To replace the switch you will have to remove the steering wheel, then remove the trim and unscrew the switch. To test the switch you need a volt meter set to ohms, then connect to both pins...
View ArticleAnswered: Nissan DAYZ 660cc. obd code p0171 is not fixed. plz help
This code is for a lean fuel mixture on bank 1. This can be caused by several things, a vacuum leak, low fuel pressure, a bad mass air flow sensor or front O2 sensor. Each item has to be eliminated as...
View Article05 frontier timing chain failure
Hi guys/gals, new to the forum. I have a 2005 frontier 4.0 in the shop that had timing chain failure. Actually the tensioner, guide plates, etc... fell apart. plastic pieces snapped, broken off. When I...
View Articlenissan ud ck450
Hello , I have a Nissan ud ck450 truck, year model 2000, I imported from japan used to Trinidad and Tobago, the engine light is now on , no one knows how to do a diagnostic test on my truck, the truck...
View Article2002 Nissan quest SE still overheating
So I have a 2002 Nissan quest SE that's over heating and we have changed the thermostat and that didn't help it and flushed the radiator and checked the cooling and the fans work fine and we even...
View ArticleNTB16-020
A new entry has been added to Knowledgebase, category 2013 Rogue Description: 2013-2015 NISSAN ROGUE; CRANK NO START OR START AND NO THROTTLE RESPONSE WITH ETC DTC STORED The vehicle is operated as...
View ArticleNTB16-021
A new entry has been added to Knowledgebase, category 2015 Altima Sedan Description: 2015 NISSAN ALTIMA, PATHFINDER, ROGUE, MURANO; ELECTRICAL SYSTEM(S) IMPROPER OPERATION AFTER OPENING OR CLOSING A...
View ArticleNTB16-022
A new entry has been added to Knowledgebase, category 2016 Maxima Description: 2016 NISSAN MAXIMA; DOOR WILL NOT OPEN OR DOOR WILL NOT LATCH The following incident, or the customer reports this...
View ArticleNTB16-023
A new entry has been added to Knowledgebase, category 2013 Altima Sedan Description: 2013-2015 ALTIMA, PATHFINDER, 2015 MURANO; POWER STEERING NOISE HEARD INSIDE VEHICLE WITH WINDOWS CLOSED A customer...
View ArticleNTB16-024
A new entry has been added to Knowledgebase, category 2009 Z Description: 2009-2016 NISSAN 370Z; 4-PISTON FRONT CALIPER BRAKE JUDDER “Brake Judder” during braking, especially when braking at highway...
View Article2002 PF Full suspension rebuild / re-fit.. requesting assistance
Howdy folks, The story is short & simple. Here we have a 2002 Pathfinder SE (I think, it's not the fancy one) 4x4, with 185,000 miles on the clock. All of the dampers (shocks / strut carts) are...
View ArticleAnswered: 03 maxima replaced both cam sensor and crank stillgets code p0340...
Hi there, This usually is a result of a faulty aftermarket sensor or possibly the timing actually being off. You could also have an issue with the wiring or the signal ring. Each of these has to be...
View ArticleAnswered: Where is the OBDIi connector on 2012 Maxima
Hi there, The OBDII connector is located under the dash to the left of the steering column near the hood release handle. More...
View ArticleAnswered: P1491 NISSAN - ultima
Hi there, The most common cause for this code is the VC bypass solenoid It stops working because of it's location and causes the code. As for the lines, check to make sure none of the steel lines have...
View Article