Previously, I had codes P0300 and P0011 on my 2005 Altima 3.5 and after reading threads on this forum, I changed oil and oil filter.
Now, when the engine is being warmed up or whenever the gear is in Park (P), SES light flashes. When I drive around the block, the flashing light disappears. I tried several times, twice yesterday and once this morning, to make sure it is not one time event. I also tried rev-up the engine while in Park, the light was still flashing. So flashing SES light disappears while car is in motion and on again when I come back to my driveway and put the gear in Park.
Engine ran rough when I had those codes. After changing oil, engine is running smoother than before but not as smooth as prior to the codes.
As aside, I do have rattling noise from timing chain which I had for, say, 3 years now. I plan to replace the chain when weather gets better.
Does anyone have this kind of experience you can share? Any comments, suggestions, advise would be appreciated.
Now, when the engine is being warmed up or whenever the gear is in Park (P), SES light flashes. When I drive around the block, the flashing light disappears. I tried several times, twice yesterday and once this morning, to make sure it is not one time event. I also tried rev-up the engine while in Park, the light was still flashing. So flashing SES light disappears while car is in motion and on again when I come back to my driveway and put the gear in Park.
Engine ran rough when I had those codes. After changing oil, engine is running smoother than before but not as smooth as prior to the codes.
As aside, I do have rattling noise from timing chain which I had for, say, 3 years now. I plan to replace the chain when weather gets better.
Does anyone have this kind of experience you can share? Any comments, suggestions, advise would be appreciated.
